400A Overhead Service Fuse Cutout Carrier

Description

400AOverhead Service Fuse Cutout Carrier

The body is made of glass reinforced polyester, this fuse cutout is unobtrusive in appearance and vandal resistant, when compared to many of the more traditional materials such as porcelain.

The fuse carrier accepts “J” type fuses to BS88 rated up to 400A. The terminals will accept solid or stranded aluminium and solid copper conductors in the range 70 to 300mm2.An adaptor is available for 25/35mm2copper or aluminium conductors. With the PVC cable sealing grommets in place the cut-out is IP43 rated and has been designed to fully comply with the performance requirements specified in BS7656:1993 for LV pole mounting fuses.

It has fuse contacts and cable terminal plates which are made of tin-plated copper. These plates incorporate M12 captive studs with nuts and washers for the reception of cable sockets(lugs) up to 300mm² (compression type only at 300mm²) with copper or aluminium conductors.

For ease of mounting to either a wall or a wooden pole, the M12 coach screw is supplied.

For cross-arm type mounting, the M12 nut, bolt and washer are supplied.

Note:

Stepped washer is recommended if the hole on the palm of lug is 16mm or greater

Fuse links

This fuse cutout is designed to accommodate standard wedge type fuse link to BS88 part 5:1988.

Tested and approved for category of duty 415 AC 80

Fixing center requirement is 82mm.

Standard fuse link ratings range from 20 to 400A.

The fuse carrier accepts “J” type fuses to BS88 rated up to 400A. The terminals will accept solid or stranded aluminium and solid copper conductors in the range 70 to 300mm2.An adaptor is available for 25/35mm2copper or aluminium conductors.With the PVC cable sealing grommets in place the cut-out is IP43 rated and has been designed to fully comply with the performance requirem ents specified in BS7656:1993 for LV pole mounting fuses.